Hardware / Kinokora Solo
SLOBeta
Kinokora Solo
Everything for one tent or small room, in one box.
Solo reads your room's air and bag temperatures, runs the crop program on its own and switches four sockets.
Hobby (Solo)
Measures
What it reads
Air temperature
°CRelative humidity
%CO₂
ppmwith the SCD41 sensor
Bag / substrate temperature
°CDS18B20 probes
Controls
What it switches
4 relay outputs
Fan, mister, heater, light or pump — you choose what each socket does in the app.
Inside
Main parts
- ESP32-S3 DevKit (recommended) or ESP32 WROOM DevKit
- SHT40 temperature + humidity sensor
- SCD41 CO₂ sensor (optional)
- DS18B20 temperature probes
- 4-channel relay board
Specs
Details
- Brain
- ESP32-S3 (8 MB flash) or ESP32 WROOM (4 MB)
- Connection
- Farm Wi-Fi, phone hotspot, or direct (Kinokora-XXXX at 192.168.4.1)
Set up
In the app
- Power the Solo
- In the Kinokora app, open Hardware and tap Add box
- Join its Wi-Fi (Kinokora-XXXX) or your farm Wi-Fi
- Set a PIN
- Tell the app what is plugged into each socket
Calibration
Guided in the app
- Temperature / humidity offset
- CO₂ fresh-air calibration
DIY
Build it yourself
Use a standard ESP32 board and install Kinokora firmware from your browser.
Safety. Mains wiring (230 V) must be done by a licensed electrician. Use a fuse or MCB rated for each load, and keep water away from connections. Read the safety guide.
Compliance
Certificates
- WPC ETA / BIS
- Will be listed here before sale
Questions
Good to know
Solo or Hub?
Solo is for one tent or small room. For bigger rooms and more sensors, use a Hub with child nodes.
Works with